Chapter 8 Maintenance and Inspection 8.6 Replacement of Timing Belt
287
[X-axis Step (14)]
Affix the motor while tension being applied to
the belt.
[Tool: Hexagon wrench]
<Caution>
As there is not enough working space, it is not
possible to apply tension to the belt with using
such a tool as a spring scale. Hold the motor
with hand, apply tension to the belt, and then
affix the motor.
[X-axis Step (15)]
Check the belt tension with using a sonic belt tension meter.
Tension to Pass: Refer to documents described in Pg. 279 to 280
Refer to “Appendix” for how to set up the sonic belt tension meter.
[Measurement Equipment: Sonic belt tension meter]
[X-axis Step (16)]
Assemble back each component in the back order of the porocedures.
Attach the front base cap (right) before putting on the operation box.
[Tools: Hexagon wrench, Phillips screwdriver]
Front Base Cap (Right Side)
Tension Meter
To Next Page
Loading...