14-16 LANDING GEAR / TROUBLESHOOTING
ICON A5 / MAINTENANCE MANUAL CHANGE C2
FIGURE 14-5
FUSES TO CHECK ON OVERHEAD CONSOLE
2. If a blown fuse is found, proceed to replace the fuse. (See “Replace Overhead Console Fuses”
on page 13-18.)
VERIFICATION METHOD:
Retract and extend the landing gear to verify actuation of the landing gear.
RELATED INFORMATION:
"Replace Overhead Console Fuses" on page 13-18
14.3.8 Landing Gear Excessive Friction Check
Use the following procedure to check for excessive friction in either the MLG or NLG installation.
TASK INFORMATION:
Type of Maintenance
To Next Page
Loading...
