ICON A5 - Page 549

LANDING GEAR / MAIN LANDING GEAR 14-41
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 14
RELATED INFORMATION:
"Seat Back Removal" on page 3-50
"Seat Back Installation" on page 3-51
"Baggage Floor Removal" on page 3-41
"Baggage Floor Installation" on page 3-42
"Main Landing Gear (MLG) Boot Removal" on page 14-41
"Main Landing Gear (MLG) Boot Installation" on page 14-42
"Inspect Flap Rigging" on page 9-65
14.6.1.3 Main Landing Gear (MLG) Boot Removal
Use this procedure to remove the MLG boot as part of the MLG boot replacement.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
NOTE: During all boot replacement installation steps, do not actuate the
brake system.
TASK INSTRUCTIONS:
1. Remove the MLG wheel and axle assemblies using the MLG Wheel and Axle Removal procedure.
(See “Main Landing Gear (MLG) Wheel and Axle Removal” on page 14-45.)
2. Break the bonds between the leg and the boot and between the boot and the Seawings™. Slide
the boot over the leg and caliper to remove.
VERIFICATION METHOD:
Procedure is complete when the MLG boot has been completely removed.