ICON A5 - Page 550

14-42 LANDING GEAR / MAIN LANDING GEAR
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 14
RELATED INFORMATION:
"Re-Bond Main Landing Gear (MLG) Boot" on page 14-44
"Main Landing Gear (MLG) Wheel and Axle Removal" on page 14-45
"Main Landing Gear (MLG) Removal" on page 14-37
"Main Landing Gear (MLG) Installation" on page 14-38
14.6.1.4 Main Landing Gear (MLG) Boot Installation
Use this procedure to install the MLG boot after it has been removed.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
Sil-Poxy
®
Silicone Adhesive
TASK INSTRUCTIONS:
1. Remove any remaining boot adhesive from the Seawings™ and landing gear leg.
2. Clean the bonding surfaces of Seawings™, leg, and boot flanges with isopropyl alcohol and a
clean cloth.
3. Retract the landing gear halfway up from the extended position. Slide the boot up until the boot’s
flange fits well against the mating flange on the Seawings™, with boot in a relaxed state. The