Keba ServoOne - Page 400

11.6.23.28Error22-35(emergencycode7305h)
Cause: Channel 1 Initialization, HIPERFACE: type key error, encoder returned an
unknown type key code
Suggested steps:
Please look at parameter (552) ENC_CH1_AbsEncStatus
Initializationencoder
channel
l Thisisprobablyasoftwareproblem!
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
11.6.23.29Error22-36(emergencycode7305h)
Cause: Channel 1 Initialization, HIPERFACE: not allowed write operation to write
protected cells or protection cells of the encoder
Suggested steps:
No further information available. Please contact your service provider.
Initializationencoder
channel
l Thisisprobablyasoftwareproblem!
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
400
11 Alarms & warnings
11.6.23.30Error22-37(emergencycode7305h)
Cause: Channel 1 Initialization, TTL: the processor board inside the servo controller
is incompatible with this function.
Suggested steps:
No further information available. Please contact your service provider.
Initializationencoder
channel
l Thisisprobablyahardwareproblem!
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
11.6.23.31Error22-38(emergencycode7305h)
Cause: Channel 1 Initialization, EndDat 2.1: error, 'PositionBits' read from encoder
Suggested steps:
Number of clocks to transmit the position from the encoder. No further information
available. Please contact your service provider.
Initializationencoder
channel
l Thisisprobablyaninternalproblemofthe
encoder!
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.