Keba ServoOne - Page 405

11.6.25.5Error24-5(emergencycode7307h)
Cause: Channel 3 Initialization, EndDat 2.1: error, 'Lines' read from encoder
Suggested steps:
Please note additional Information in the message window of the DriveManager.
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.25.6Error24-6(emergencycode7307h)
Cause: Channel 3 Initialization, EndDat 2.1: error, 'MultiTurn' read from encoder
Suggested steps:
Please note additional Information in the message window of the DriveManager.
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
405
11 Alarms & warnings
11.6.25.7Error24-7(emergencycode7307h)
Cause: Channel 3 Initialization, EndDat 2.1: error, 'SingleTurn' read from encoder
Suggested steps:
Please note additional Information in the message window of the DriveManager.
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.25.8Error24-8(emergencycode7307h)
Cause: Channel 3 Initialization, EndDat 2.1: CRC error, position data from encoder
Suggested steps:
The transmission is probably disturbed. Please check the wiring to the encoder.
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.