Keba ServoOne - Page 414

11.6.29.2Error30-2(emergencycode5300h)
Cause: Initializationerrorcalculatingmotortorqueconstant
Suggested steps:
Check motor parameters
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
414
11 Alarms & warnings
11.6.29.3Error30-3(emergencycode5300h)
Cause: Error while calculating flux model of asynchr. motor
Suggested steps:
Check motor parameters (Rrot, Lsig, Lmag) and magn.current Imag
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.