Keba ServoOne - Page 419

11.6.32.3Error33-2(emergencycode5300h)
Cause: Internal timing error
Suggested steps:
Please restart device.
Computationalloadintime-
criticaltaskofaxismoduleis
toohigh.
l Pleasereducecomputationalloadby
removingparametersfrommapping.
l De-activatefeaturesofcontrolsystemor
motioncontrol.
Thisisprobablyasoftware
issue.
l Pleasetrytoswitchtoadifferentversionof
devicefirmware.
l Saveyourdatasetandresettheaxismoduleto
factorysetting.Seeiftheerrorpersists,orifit
comeswithactivatingacertainfeature.
11.6.32.4Error33-3(emergencycode5300h)
Cause: Unknown EXCEPTION in TC-safety
Suggested steps:
Reset device!
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
419
11 Alarms & warnings
11.6.32.5Error33-4(emergencycode5300h)
Cause: Internal timing error
Suggested steps:
Run time error, not enough CPU performance, check PLC program
Computationalloadintime-
criticaltaskofaxismoduleis
toohigh.
l Pleasereducecomputationalloadby
removingparametersfrommapping.
l De-activatefeaturesofcontrolsystemor
motioncontrol.
Thisisprobablyasoftware
issue.
l Pleasetrytoswitchtoadifferentversionof
devicefirmware.
l Saveyourdatasetandresettheaxismoduleto
factorysetting.Seeiftheerrorpersists,orifit
comeswithactivatingacertainfeature.