Keba ServoOne - Page 426

11.6.34.11Error35-10(emergencycode7305h)
Cause: ENC CH1 ENDAT: error, diagnosis
Suggested steps:
endat encoder cyclic diagnosis monitoring error, check encoder
Theencoderisnot
connectedornotworking
properly.
l Ifthisisencoderhasanaloguesignals,please
checkthesignalamplitudevs.parameter
EncObsMin
l Checkcabling.Ifavailable,pleasetryanother
encoderandcable.
l Seedetailederrorinformation(>>)foramore
detaileddescription.
11.6.34.12Error35-11(emergencycode7307h)
Cause: ENC CH3 ENDAT: error, diagnosis
Suggested steps:
endat encoder cyclic diagnosis monitoring error, check encoder
Theencoderisnot
connectedornotworking
properly.
l Ifthisisencoderhasanaloguesignals,please
checkthesignalamplitudevs.parameter
EncObsMin
l Checkcabling.Ifavailable,pleasetryanother
encoderandcable.
l Seedetailederrorinformation(>>)foramore
detaileddescription.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
426
11 Alarms & warnings
11.6.34.13Error35-12(emergencycode7307h)
Cause: Channel 3 cyclic, HDSL: status error --> position invalid
Suggested steps:
'Please check the encoder and wiring.
Encoderchannel,cyclic
evaluation
l Errorduringthecyclicevaluationofan
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
HIPERFACE-DSL,cyclic
processing
l Errorduringthecyclicexecutionof
HIPERFACE-DSL(HDSL).
l Theproblemcouldhavebeencausedby
mechanicalshock.
l Ifshort-timefailuresaretolerable,use
parameterENC_CH3_ErrorToltotoleratea
givennumberoffailures.Scopetheerror
counterENC_CH3_ErrorCounttomonitorthe
behaviour.Incaseofanerror,positionis
estimatedfrompreviousdata.