Keba ServoOne User Manual

11.6.42.3Error45-2(emergencycodeFF00h)
Cause:
Movementrequestedwhichwaslimitedbyreversinglock,limitswitchorreferencev
aluelimitation.Lockactiveinbothdirections
Suggested steps:
Check plausibility of limit switches and/or software limits
Thereferencevalueviolates
alockorlimitswitch.
l Pleasecheckreferencevalues.Ifthisaxisis
workingincyclicsynchronousmode,makea
scoperecord.
l Checkfactorgroupsettings.
l Checkmodeofoperation.
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
437
11 Alarms & warnings
11.6.42.4Error45-3(emergencycode8612h)
Cause: Software limit switch overtravel detected, traversing task rejected
Suggested steps:
Quit error and change reference value
Thereferencevalueviolates
alockorlimitswitch.
l Pleasecheckreferencevalues.Ifthisaxisis
workingincyclicsynchronousmode,makea
scoperecord.
l Checkfactorgroupsettings.
l Checkmodeofoperation.
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.

Keba ServoOne Specifications

General

Brand	Keba
Model	ServoOne
Category	Controller
Language	English