Keba ServoOne - Page 449

11.6.45.15Error49-14(emergencycode6100h)
Cause: Error on safety controller SR2 detected
Suggested steps:
Read additional information, check safety system or wiring and acknowledge
alarm/error
Extendeddiagnosisofsafety
errors/alarms.
l Furtherinformationontheerror/alarmcode
canbefoundinthe"ServoOnefunctional
SafetyErrorDescription".
Anerroroccuredatthe
safetycontroller.
l Pleasecheckthesafetyprogramandthe
wiringofthesecuritysystem.
l Pleaseacknowledgetheerrorontheaffected
device.Subsequentlythealarmmustbe
acknowledgedatthesafetymastertoresetthe
networkstatusto"RUN".
l Pleaserestarttheapplication(24Vreset).
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
449
11 Alarms & warnings
11.6.45.16Error49-15(emergencycode6100h)
Cause: Safety network alarm, initiated by safety master
Suggested steps:
Read additional information, check safety system or wiring and acknowledge
alarm/error
Extendeddiagnosisofsafety
errors/alarms.
l Furtherinformationontheerror/alarmcode
canbefoundinthe"ServoOnefunctional
SafetyErrorDescription".
Anerroroccuredatthe
safetycontroller.
l Pleasecheckthesafetyprogramandthe
wiringofthesecuritysystem.
l Pleaseacknowledgetheerrorontheaffected
device.Subsequentlythealarmmustbe
acknowledgedatthesafetymastertoresetthe
networkstatusto"RUN".
l Pleaserestarttheapplication(24Vreset).