Keba ServoOne - Page 468

Once the safety prompt is confirmed, the “Manual mode” window will be enabled,
after which you can select a control mode and configure it for manual operation.
Depending on the control mode you selected, one to four configuration tabs will
appear:
l Atablewiththeparametersthatarespecifictotherelevantcontrolmodebut
thatwillonlyapplywhenusingmanualmode(e.g.acceleration,
deceleration,setpoint,speed,etc.)
l Homing(seeSection"Homing"onpage252)
l Jogmode,whichcanbeusedtomovethemotorstep-by-stepinapositiveor
negativedirectionwithtwodifferentspeeds.
l Reversingoperation,inwhichthemotorcanbemovedbackandforthwith
adjustableaccelerationsandspeeds.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
468
15 Manual mode
Image 15.2: “Manual mode” window (enabled) - Control mode tab