Keysight U8480 Series - Page 229

SENSe Subsystem 8
U8480 Series Programming Guide 229
Reset condition
On reset, the value is set to 0.
Query
[SENSe[1]:]FREQuency[:CW|:FIXed]:STEP?
This query retrieves the number of steps in the triggered frequency sweep.
Query example
Error messages
– If the parameter is set <0 or >250, error –222, “Data out of range” occurs.
–If TRIGger:SOURce is not set to EXT, error –221, “Settings conflict” occurs.
FREQ:STEP? Returns the number of steps in the frequency sweep.