MD-11 Flight Crew Operations Manual
k
FMS -
Controls and Displays
FMS.30.131
•GW entry.
•ZFW entry.
MULTIPLE ENGINEOUT - More than one engine inoperative.
NEW CRZ ALT - FLNNN - A change is made to the active primary cruise altitude
which was not pilot initiated. For example, entry of an altitude constraint that is
higher than the cruise flight level causes the cruise flight level to be raised to the
altitude constraint value.
NO DESTINATION - Appears for the following:
• An attempt is made to access the APPROACH page with no destination in
the active primary flight plan.
• An entry of a descent constraint is attempted without a destination in the
affected flight plan.
NO FMS SPD/PROF - No Perf database exists for the programmed engine or
airframe or the engine detected by the FCC does not match programmed engine
specified to the FMC at engine start.
NOT ALLOWED - A key input is not allowed or is not functional.
NOT IN DATA BASE - An IDENT entry is attempted that is not in the nav
database and/or the pilot defined waypoint list.
NOT ON INTC HEADING - Present track will not intercept the selected course
for the DIR/INTCP function.
PLEASE WAIT - FMCs are re synchronizing to the dual state.
RADIO ONLY NAVIGATION - Appears on transition to Radio Only navigation
mode (no inertial navigation).
REF NAVAID DESELECTED - A procedure specified navaid is deselected while
the aircraft is in the terminal area.
REF NAVAID UNTUNEABLE - A procedure specified navaid has been
blackballed by the FMS and is not used in position calculation.
RTA ERROR AT XXXXXXX - RTA constraint will be missed by more than 30
seconds.
SEC F-PLN CLEARED - When an attempt is made to add a guidance leg to the
Active Primary or Active Alternate flight plans, but there is no memory available,
then the Secondary flight plans are sacrificed for space and this message is issued.
SEC RTA REMOVED - RTA constraint in active (secondary) flight plan is
automatically deleted as an indirect result of aircraft or crew action.
SENSOR FAIL - Sensor transitions to fail on SENSOR STATUS page.
SENSOR IS INVALID - Sensor is declared invalid for FMC use.
October 02, 2006
To Next Page