Korg Oasys - Page 112

Creating songs (Sequencer mode)
104
WhensamplingviaS/P DIF,youmustsettheGlobal
modeSystemClockappropriately.Formore
information,pleasesee“SystemClock”onpage 702
oftheParameterGuide.
Bus Select (IFX/Indiv.)
Thisspecifiestheoutputbusforeachaudiosignal.
Off:Theexternalaudioinputsignalwillnotbesentto
anybus.However,youcanstillrecordtheexternal
audiosignaldirectlybyusingtheP0:Play/REC–Audio
TrackMixerpageRECSourcesettingtochoosean
externalinput(AudioInput
1–4,S/P DIFL,S/P DIFR)
forrecording.
L/R:Theexternalaudioinputsignalwillbesenttothe
L/Rbus.Choosethiswhenyouwantothersignalssuch
theOASYS’internaltonegeneratortoberecorded
alongwithanexternalaudiosource.SetRECSourceto
L/R.
IFX1…12:Theexternalaudioinput
signalwillbesent
totheIFX1–12bus.Choosethiswhenyouwantto
applyaninserteffectwhilerecording.SetRECSource
tomatchthepost‐IFXBusSelectsetting.
1…8:Theexternalaudioinputsignalwillbesentin
monauraltoINDIVIDUAL1,2,3,4,5,6,7,
or8.
1/2…7/8:Theexternalaudioinputsignalwillbesent
viaPaninstereotoINDIVIDUAL1and2,3and4,5
and6,or7and8.SetRECSourcetothecorresponding
INDIV.setting.
BeawarethatifyouchangeBusSelect(IFX/Indiv.)
fromOfftoL/R
orIFX,thevolumelevelfrom
AUDIOOUTL/MONOandRjacksorfromthe
headphonejackmayincreaseabruptly.Pleaseuse
caution.
FX Ctrl Bus (FX Control Bus)
ThissendstheexternalaudioinputsignaltotheFX
Controlbus(stereotwo‐channel(FXCtrl1,2)).For
moreinformation,see“FXControlBuses”onpage 790
oftheParameterGuide.
REC Bus
ThissendstheexternalaudioinputsignaltotheREC
buses(fourmonochannels:1,2,3,4).
TheRECbusesarededicatedinternalrecordingbuses
thatyoucanuseforrecordingorsamplingaudio
tracks.
RecordingbecomespossibleifyouchooseaRECbus
asthe“SourceBus.”Forexample,you
canusetheREC
busesifyouwanttorecordonlyanaudioinputsource
thatisbeingplayedalongwiththesongbeingoutput
fromtheL/Rbus(i.e.,recordtheinputsource,butnot
thesongplayback).Youcanalsomixseveralaudio
inputstotheRECbuses,
ormixthedirectsignalfrom
audioinputstoRECbusesalongwithpost‐IFXsound
andrecordtheresult.
Off:ThesignalwillnotbeoutputtotheRECbuses.
NormallyyouwillleavethisOff.
1,2,3,4:Theexternalaudioinputsignalwillbesentto
thespecified
RECbus.ThePansettingisignored,and
thesignalissentinmonaural.
1/2,3/4:Theexternalaudiosignalwillbeoutputtothe
RECbusesinstereo.AccordingtothePansetting,it
willbesentinstereotobuses1and2,or3and4.
Send1 (to MFX1), Send2 (to MFX2)
Thesespecifythelevelatwhichtheexternalaudio
inputsignalwillbesenttothemastereffects.
Send1(toMFX1)sendsthesignaltomastereffect1.
Send2(toMFX2)sendsthesignaltomastereffect2.
IfBusSelect(IFX/Indiv.)issettoIFX1–12,thesend
levelstothemaster
effectsarespecifiedbytheSend1
andSend2settingsthatfollowIFX1–12.
PLAY/MUTE
Theseindicatewhethereachexternalaudioinput
signalisinPlayorMutecondition.
UsetheMIXPLAY/MUTE1–6switchestochangethe
status.
SOLO On/Off
ThisindicatestheSOLOstatusofeachexternalaudio
inputsignal.UsetheMIXSELECT1–6switchesto
changethesolostatus.
SoundwillbeoutputonlyfromchannelswhoseSOLO
isOn.Otherchannelswillbemuted.Solooperation
includesbothMIDItracksandaudiotracks.
Pan
Thisspecifiesthepanningofeachexternalaudioinput
signal.Ifyouareinputtingastereoaudiosource,you
willnormallypantheinputstoL000andR127
respectively.
LINE ONOFF MIC
C
D player, etc.
Condenser
mic
Guitar
Effect unit
Synthesizer