Korg Oasys - Page 154

Sampling (Open Sampling System)
146
Inthisexamplewe’llexplainhowyoucanuseAuto
SamplingSetuptomakethesettingsdescribedabove
intheprecedingsection.
1. Carryoutsteps1and2describedinthepreceding
section.
2. PresstheAudioInput/Samplingtabtoaccessthe
P0:Play–AudioInput/Samplingpage.
3. ChoosetheAutoSamplingSetuppage
menu
command.Adialogboxwillopen.
4. Makethefollowingsettingsinthedialogbox.
“ResampleProgramPlay”:On
Thismakestheappropriatesettingsforresampling
yourplayingonaprogram.
“Saveto”:RAM
TheresampleddatawillbewrittenintoRAM
memory.
“ConverttoProgram”:On
“Program”:asdesired
Afterresampling,thedatawill
automaticallybe
convertedintotheprogramnumberyouspecifiedin
“Program.”
5. PresstheOKbuttontoexecutethecommand.
TheOASYSwillmaketheappropriatesettingsfor
resampling.
6. Resampleyourplayingasdescribedinsteps4and
5oftheprecedingsection.
7. Listentothesoundyouresampled.
AccesstheProgramP0:Play–
Mainpage.Pressthe
MODEPROGRAMswitch,thentheEXITswitch,
andthentheMaintabintheupperlineoftheLCD
screen.
Selecttheprogramyouspecifiedfor“Program”in
thedialogbox.
PlaytheC2keyandyouwillhearthesoundyou
resampled.
Mixing a KARMA-generated drum phrase
with a live guitar input, and sampling the
result
Here’showyoucanresampleKARMAtogetherwith
anexternalaudioinputsource.
Inthisexample,wewillexplainhowaguitar
connectedtotheAUDIOINPUTjackcanbeplayed
alongtoadrumphraseplayedbytheOASYS,andhow
bothcanbesampledtogether.
Samplingcanbeperformedin
asimilarwayin
CombinationandSequencermodesaswellasin
Programmode.
1. PresstheMODEPROGRAMswitchtoenter
Programmode,andselectthedrumprogramthat
youwanttoresample.
2. TurntheKARMAfunctionon(KARMAON/OFF
switchlit),playthekeyboard,andverifythatthe
drumphrase
plays.
TurnLATCHon.PresstheLATCHswitchtomakeit
light.
Alsoadjustthetempo“q”asdesired.
3. PresstheKARMAON/OFFswitchtoturnoffthe
KARMAfunction.
4. ConnectyourguitartotherearpanelAUDIO
INPUT1jack.
PresstheAUDIOINPUTMIC/LINEswitchinward
toselecttheLINE
position,andsettheLEVELknob
ataboutthecenter.
Ifyouconnectaguitarwithpassivepickups(i.e.,a
guitarthatdoesnotcontainapreamp),youwillbe
unabletosampleitatthecorrectlevelbecauseofthe
impedancemismatch.Suchguitarsshouldbe
routedthroughapreamp
oraneffectunit.
5. PresstheSamplingtabtoaccesstheP0:Play–
AudioInput/Samplingpage.
Makethefollowingsettings.
–AudioInput–
UseGlobalSetting:Off
INPUT1
BusSelect(IFX/Indiv.):L/R
Pan:asdesired
Level:127
RECBus:Off
TheinputfromAUDIOINPUT1willbesenttothe
L/Rbus.
–RECORDINGLEVEL–
RecordingLevel:0.0
Thisisthedefaultsettingforresampling.
–SamplingSetup–
SourceBus:L/R
ThesoundsenttotheL/Rbuswillbesampled.
Trigger:SamplingSTARTSW
PresstheSAMPLINGRECswitchtoenterrecord‐
standbymode.ThenpresstheSAMPLING
START/STOPswitchtostartsampling.
MetronomePrecount:4
WhenyoupresstheSAMPLINGRECswitchto
enterrecord‐standbymodeandthenpressthe
SAMPLINGSTART/STOPswitchtostartsampling,
afour‐beatcountwillsound,andthenrecording
willbegin.(Themetronomewillnotsoundduring
recording.)
Saveto:RAM
Thesamplewillberecorded
toRAMmemory.
Guitar
Effect unit
OFF LINE