2NJ/2RK-1
2-101
6. Remove the cassette heater wire(b) combining from the wire saddle(a) and then fix it again.
Figure 2-197
7. Connect the cassette heater connector(a) to the power source PWB(B)(YC4).
Figure 2-198
8. Reattach the lower rear cover in the original position.
9. Reattach the right rear cover in the original position.
10. Reattach the left rear cover in the original position.
11. Reattach the controller cover in the original position.
12. Cassette heater control setting (100V model only)
*: The model which the cassette heater is normally equipped and connecting to the connector in the cassette heater
connecting procedure.
*: If the setting is not executed, the cassette heater is not turned on. (Default setting is OFF)
1.Input "327" using the numeric keyboard and press the [Start] key.
2.Select [Mode 1] or [Mode 2]
3.Press the [Start] key and then set.
4.Press the [Stop] key.
* :When reflecting the setting, skip the maintenance mode, operate the shut-down from the normal
screen and turn the power switch ON/OFF.
b
a
YC4
a
b
To Next Page
Loading...
