Kyocera TASKalfa 8002i - Page 509

2WA/2NJ/2RK
4-181
14. When replacing the main PWB, remove
the SSD by the following procedure.
15. Remove one screw (a)(M2).
16. Remove the SSD (b) from the connec-
tor (c).
*: Use a Phillips 1 screwdriver and take care
not to damage the screws.
17. Check or replace the main PWB (a) and
then reattach the parts in the original
position.
IMPORTANT
To avoid damage when attaching the SSD (b),
align the screw hole (d) to the positioning boss
(e).
Do not replace the main PWB, engine PWB
and SSD at the same time.
Figure 4-266
a
b
e
d
c
14
j
0415