2WA/2NJ/2RK
6-52
Setting: Interval Number
1.Change the setting value by using [+] [-] key or the numeric keypad.
* :If becomes setting value × 1000 counts during the consecutive copy, stop the printing oper-
ation and turn the below motor on.
Vibration motor(Toner collection box)
Toner fan motor(Toner collection box)
Toner assist fan
2.Press the [Start] key and then fix the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
Turns the exposure lamp on.
Purpose
Light the exposure lamp to confirm.
Method
1.Press the [Start] key.
2.Select the item to operate.
3.Press the [Start] key. Lamps are lit.
* :Press the [Stop] key to turn the lamp off.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Items Contents Setting range Data
variation
Initial
setting
Cnt Changes the fan control timing cycle. 0 to 10 1 -
U061 Lamp lighting check
(Message: Check Lamp ON)
Items Contents
CCD Turns the exposure lamp on
CIS Turn the CIS lamp on (when the simultaneous duplex scanning docu-
ment processor is installed)
To Next Page
Loading...
