2WA/2NJ/2RK
6-51
Contents
Sets the conveying fan motor drive mode during paper conveying.
Purpose
A fan is added in the conveying unit so that the leading edge of paper is conveyed along with the
conveying path to prevent paper creases.
Setting
1.Press the [Start] key.
2.Select the item to set.
Setting: Fan Mode
1.Select the item.
* :Initial setting: Mode1
2.Press the [Start] key to set the setting value.
Setting: Cooling Mode
1.Change the setting value by using [+] [-] key or the numeric keypad.
* :When increases the setting value, the temperature in machine rises and the developer life
shortens.
2.Press the [Start] key to set the setting value.
U059 Fan mode setting
(Message: Set Fan Mode)
Items Contents
Fan Mode Sets the temperature which is driven the developer fan motor
Cooling Mode Adjusts the temperature to be a Refer ence switching the developer fan
motor control.
Interval Cycle Changes the fan control timing cycle.
Items Contents
Mode1 Setting temperature: Normal
Mode2 Setting temperature: Lower the temperature threshold than mode1
(WUP, temperature at READY → mode1 temperature -7 (°C))
(Temperature at PRINT → mode1 temperature -3 (°C))
Mode3 Setting temperature: Lower the temperature threshold than mode2
(WUP, temperature at READY → mode1 temperature -22 (°C))
(Temperature at PRINT → mode1 temperature -8 (°C))
Auto Start from mode2 at power on and sleep recovery and change to mode3
when the developer temperature BK becomes 38 (°C) or more.
Power source
During ON is not back to mode2 from mode3.
Items Contents Setting range Data
variation
Initial
setting
Cooling
Mode
Sets the Cooling Mode -3 to 3 °C 0
To Next Page
Loading...
