2WA/2NJ/2RK
6-112
5.Press the center of "+".
6.[Initialize Completed] appears after setting
and the touch panel is automatically cor-
rected.
7.After finishing setting, the [Check] screen is
automatically displayed.
Method: Check
Single Tap Check
1.Press the indicated three "+", and then check
the display position.
2.Check that the gap of the X and Y axis of the
displayed coordinate is 6 or less.
* :If out of the specified value, select [Initial-
ize] and press the [Start] key to return to
Step.1.
Press the center of the "+" sign.
*Press it using a tool with a fine tip.
If you cannot proceed to the next step, press the Stop key and try again.
Initialize completed.
Initialize
Single Tap Check.
Press the center of the "+" sign.
*Press it using a tool with a fine tip.
If you need to perform initialization again, select "Initialize" and press the Startkey.
Initialize
Multi Tap
Check
(13, -3)
(-8, 15)
(4, -1)
Single Tap Check.
Select "Mult Tap Check" and press the Startkey to go to the next step.
If you need to perform initialization again, select "Initialize" and press the Startkey.
To Next Page
Loading...
