2WA/2NJ/2RK
6-175
Method: DP FD (Chart A)
Automatic input of the target value
1.Set the specified original (P/N: 7505000005) face-down on the DP.
2.Enter maintenance item U411.
3.Select [Target].
4.Select [Auto].
5.Press the [Start] key.
6.Select [DP FD(ChartA)].
7.Press the [Start] key to read the bar code of the original chart and to start the automatic adjust-
ment.
8.When automatic adjustment has normally completed, [OK] is displayed.
* :When automatic adjustment has normally completed, [OK] is displayed. If an error occurs
during auto adjustment, error code "NGXX" is displayed and operation stops. In this case,
check the error and execute the automatic adjustment again.
To Next Page
Loading...
