Kyocera TASKalfa 8002i - Page 963

2WA/2NJ/2RK
7-103
J0215: Side multi feeder release detection
Object: Side multi feeder
Detected the side multi feeder release during printing.
J0300: Paper eject completion non-detection jam
Object: 4000-sheet finisher
The paper eject completion is not communicated from the finisher.
Step Check description Assumed cause Measures Reference
1 Checking Side Multi
Feeder
The Side Multi Feeder is
not engaged with the main
unit.
Check if the side multi feeder
is securely installed and rein-
stall it if necessary. And if the
exterior cover of the side
multi feeder is deformed,
repair or replace it.
2 Checking the PF set switch The PF set switch does not
properly operate.
Reattach the PF set switch
and reinsert the connector. If
not repaired, replace it.
Step Check description Assumed cause Measures Reference
1 Resetting the main power The controller does not
activate properly.
Remove a piece of paper,
etc. at each conveying sec-
tion and check the sensor.
Next, turn the power switch
and main switch off. Turn the
main switch and power
switch on when passing 5
seconds.
2 Checking the connection The connector is not prop-
erly connected or the wire
is faulty.
Clean the terminal of the fol-
lowing wire connectors and
reinsert the connectors.
Replace the wire when it has
no continuity.• DF main PWB
- Engine PWB
Wiring dia-
gram
3 Firmware upgrade The firmware does not
properly activate.
Upgrade the firmware to the
latest version.
Firmware
Update
4 Replacing the DF main
PWB
The DF main PWB is
faulty.
Replace the DF main PWB. Detaching
and reat-
taching the
DF main
PWB