2WA/2NJ/2RK
7-106
J0501/J0502: No paper feed from the cassette
Condition: The paper stops at the feed pulley.
After the feed clutch turns on during paper feed from cassette 1, 2, the feed sensor does not turn on since the
paper stops at the feed pulley.
Step Check description Assumed cause Measures Reference
1 (In case of the paper bun-
dle jam) Checking the
paper
The cut-end of the paper is
crushed.
Fan the paper well and load it
by reversing the paper direc-
tion
2 (In case of the paper bun-
dle jam) Checking the
paper
The paper leading edge is
bent.
Remove the bent paper.
3 (In case of the paper bun-
dle jam) Checking the
paper
foreign objects are on the
paper.
Remove the paper with for-
eign objects.
4 (In case of the paper bun-
dle jam) Checking the
retard pulley
The paper separation force
of the retard pulley is not
enough.
Clean the retard pulley sur-
face. If it is worn down,
replace it.
Detaching
and reat-
taching the
pickup pul-
ley, feed
pulley and
retard pul-
ley
5 (In case of the paper bun-
dle jam) Checking the
retard spring
The retard spring comes
off.
Reattach the retard spring.
6 Checking the paper path The paper is caught with a
piece of paper, etc.
A piece of paper or the for-
eign objects are adhered on
the conveying path, or if the
parts such as the guide or
the actuator has burrs,
remove them.
7 Checking the feed pulley Conveying capability of the
feed pulley is not enough.
Clean the feed pulley sur-
face. If it is worn down,
replace it.
Detaching
and reat-
taching the
pickup pul-
ley, feed
pulley and
retard pul-
ley
8 Checking the pressure
release lever and the
retard holder
The press-release lever
and the retard holder are
attached oppositely.
Reattach the pressure
release lever and the retard
holder.
9 Checking the paper feed
clutch
Feed pulley does not
rotate as the feed clutch is
not linked.
Execute U032 [Feed1] or
[Feed2]. If feed clutch 1 or 2
does not properly operate,
reattach it and reinsert the
connector. If not repaired,
replace the clutch.
Executing
U032
To Next Page
Loading...
