2WA/2NJ/2RK
7-107
J0501/J0502: No paper feed from the cassette
Condition: The paper leading edge passes the feed pulley.
After the feed clutch turns on during paper feed from cassette 1, 2, the paper leading edge comes out from the
cassette but the feed sensor does not turn on.
10 Checking the paper feed
motor
The feed motor does not
properly operate.
Execute U030 [Feed]. If the
feed motor does not properly
operate, reattach it and rein-
sert the connector. If not
repaired, replace it.
U030 Exe-
cution
11 Checking the drive parts The drive from the feed
motor is not properly trans-
mitted.
Reattach the drive parts of
the feeding motor. If not
repaired, replace the parts
faulty in operation. Or replace
the feed drive unit.
Detaching
and Reat-
taching the
feed drive
unit
Step Check description Assumed cause Measures Reference
1 Checking the feed pulley Conveying capability of the
feed pulley is not enough.
Clean the feed pulley sur-
face. If it is worn down,
replace it.
Detaching
and reat-
taching the
pickup pul-
ley, feed
pulley and
retard pul-
ley
2 Checking the pressure
release lever and the
retard holder
The press-release lever
and the retard holder are
attached oppositely.
Reattach the pressure
release lever and the retard
holder.
3 (When the paper skew
occurs) Relocating the
paper width guides
The locations of the paper
width guides do not fit with
the paper size.
Relocate the paper width
guides to fit them with the
paper size.
4 (When the paper skew
occurs) Checking the actu-
ator and the spring
The actuator does not
operate properly.
The actuator or the spring is
deformed, or if not properly
operate, replace it.
5 (When the paper skew
occurs) Checking the con-
veying guide
The paper is caught with
the conveying guide.
Reinstall the conveying
guide. If there are burrs on
the conveying surface of the
conveying guide, remove
them. If not repaired, replace
it.
6 (When the paper skew
occurs) Checking the
paper path
The paper is caught with a
piece of paper, etc.
A piece of paper or the for-
eign objects are adhered on
the conveying path, or if the
parts such as the guide or
the actuator has burrs,
remove them.
Step Check description Assumed cause Measures Reference
To Next Page
Loading...
