Starting production
106 ProtoMat
®
S62
5.7 Starting production
In the Phase selection list (on the function bar), always the current
(most recently processed) production phase is displayed. If a production
phase is finished (all activated data has been executed), you first have to
select the next production phase and must activate the desired data.
Note: If no data has been activated for processing, BoardMaster will consider
the production phase to be finished and the message "End of the phase !"
appears.
Starting a production phase
1. Make sure that the required production phase is displayed in the
phase selection list.
2. Click on Start.
The required tool is picked up and production commences. You might
need to set 2.5 D mode and the milling depth/width.
To Next Page
Loading...
