LPKF ProtoMat S62 - 3.1.2 Milling depth;width limitation

The milling/drilling head
30 ProtoMat
®
S62
Pause position In the pause position, the milling/drilling head is on the right and the tra-
versing table is at the front. Use the pause position to load the circuit
board plotter.
Home position The home position serves as the BoardMaster reference point and lies
exactly on the mirror axis of the traversing table. The milling/drilling head
is positioned exactly above the left pass hole pin; the traversing table is in
the central area.
Zero position The zero position corresponds to the zero point of the X/Y co-ordinate
system and is positioned at the front left on the traversing table. In the
zero position, the milling/drilling head is located on the left edge of the tra-
versing range and the traversing table is at the back.
3.1.2 Milling depth/width limitation
The milling depth limiter is located directly on the milling/drilling head.
The penetration depth of the surface tools can be set with the setting
wheel in order to regulate material removal.
Fig. 11: Setting wheel for
milling depth limiter
1 Setting wheel for milling depth limiter
1