LPKF ProtoMat S62 - 1. For your safety; 1.1 Designated use

For your safety
Operating Manual 7.1 Rev.: 18.06.2008 15
1. For your safety
In this chapter you will find information concerning proper use, liability and safety in connection
with the operation of the ProtoMat
®
S62.
If, after reading this manual, a situation should arise in which you are not sure how to use or
service the ProtoMat
®
S62, you should contact LPKF Support or consult a person skilled in the
art.
1.1 Designated use
The ProtoMat
®
S62 has been designed for the production of electric cir-
cuit boards with up to six layers and the processing of a variety of sign
and housing materials.
The ProtoMat
®
S62 can be used to:
• Mill and drill single-sided and double-sided printed circuit boards
• Mill and drill multi-layer materials
• Mill SMD solder paste stencils
• Mill solder stop foils
• Engrave housing plates and signs
• Mill cut-outs and contours
• Drill through flat materials
The ProtoMat
®
S62 is able to process the following materials:
• GFK/CFK base material
• PTFE/ceramic composite base material
• Wood
• Non-ferrous metals
– Aluminium acc. to DIN EN 573: EN AW-6012)
– Brass acc. to DIN EN 1412: CW603N
• Plastics
– Polyoxymethylenes
– ABS copolymers
The ProtoMat
®
S62 may only be used for the applications and materials
cited in this document.
The circuit board plotter may only be used together with the version of the
LPKF Software BoardMaster included in the scope of delivery. If you
want to use a different BoardMaster version, please contact the LPKF
Support first.