Designated use
16 ProtoMat
®
S62
Operation of the circuit board plotter is only permitted subject to sufficient
dust extraction provision, which must include fine dust filtering. We rec-
ommend the use of the LPKF dust extraction with integrated HEPA filter.
If you want to use a different system for dust extraction, you should con-
tact LPKF Service first.
Improper use The ProtoMat
®
S62 must not be used for processing highly combustible
materials, sealed containers, hollow pieces, textiles or foodstuffs. The
processing of parts of the body (e.g. finger nails) is not permitted.
If you are not sure about the use of the materials to be processed, you
should contact LPKF Support.
Liability for function and damage
The ProtoMat
®
S62 has been designed and built in accordance with the
state of the art and acknowledged safety engineering guidelines.
Nevertheless, its use may constitute a risk to the life and limb of the user
or of third parties, or cause damage to the machine and to other
equipment or property.
Disclaimer The manufacturer/seller cannot be held liable for damage caused by the
following actions/conditions:
• Improper handling, including any use not mentioned in this manual.
• Use in an unsuitable environment
• Installation and operation by insufficiently informed or unauthorised
persons
• Non-compliance with legal safety requirements
• Non-observance of technical information
• Installation carried out incorrectly
• Insufficient supply facilities
• Missing, faulty or insufficient maintenance
• Unauthorised technical modifications
• Use of non-original spare parts and those not specifically designed
for this machine/device
• Use of non-approved workpieces and/or materials
To Next Page
Loading...
