LPKF ProtoMat S62 - Switching off the Circuit Board Plotter; Switching off the LPKF Dust Extraction

Manual tasks and settings
Operating Manual 7.1 Rev.: 18.06.2008 53
2. Click on Yes.
The milling/drilling head and the working table will move to the Zero posi-
tion.
Note: If you click on No, the Zero position must be reinitialized at the next
start, which is time-consuming.
[ ] Now you can switch off the circuit board plotter and, if necessary, the dust
extraction.
II. Switching off the circuit board plotter
1. Switch the main switch on the circuit board plotter (in the acoustic
cabinet) to the position 0.
The lighting of the milling/drilling head goes out.
[ ] Now you can switch off the dust extraction and shut down the computer.
III. Switching off the LPKF dust extraction
The LPKF dust extraction must be switched off manually only if it is
used in continuous operating mode. During the automatic operating
mode it is switched off automatically together with the circuit board plot-
ter.
If your ProtoMat
®
S62 is equipped with another dust extraction, famil-
iarise yourself with the relevant operation information.
1. Set the main switch of the LPKF dust extraction to the position OFF
(centre position).
or:
Set the main switch of the LPKF dust extraction to the position
Connection to LPKF ProtoMat, to use the dust extraction after
the next start ProtoMat
®
S62 in the automatic operating mode.
[ ] The LPKF dust extraction is switched off.