Inserting pass hole pins
88 ProtoMat
®
S62
10. If the dust extraction does not shut down automatically, click on the
Vacuum off button on the function bar.
11. On the menu bar, click on the Move to pause button.
The milling/drilling head moves to the pause position.
12. Remove any swarf with a brush.
13. Remove the sinter plate from the vacuum table.
[ ] To complete the pass hole system, you simply need to insert the pass hole
pins (see "Inserting pass hole pins") and mount the plastic base on the
milling depth limiter(see "Mounting the plastic base/brush head" on
page 63).
4.13 Inserting pass hole pins
Only use pass hole pins designed for your equipment configuration.
Note: For inserting the pass hole pins into the vacuum table, the sinter plate has
to be taken off.
Equipment Pass hole pins
Basic equipment: 3 mm x 8 mm
Vacuum table 3 mm x 10 mm
To Next Page
Loading...
