OIL SYSTEM MODULE A SSE MBLY A ND SECONDARY FILTRATION 285
2
1
3
4
5
6
7
8
11
H13035
5
9
10
Figure 410 Oil system module and secondary filter assembly
1. Oil system module assembly
2. Bolt, M8 x 30 (8)
3. Hose, 1 in O.D.
4. Hose clamp (2)
5. O-ring (2)
6. Secondary filtration filter
assembly
7. Bolt, M8 x 25 (6)
8. Oil cooler drain tube
9. Support bracket bolt, M8 x 16
10. Bolt, M8 x 20 (8)
11. Oil filter (spin-on)
11. Remove oil cooler drain tube support bracket bolt
(M8 x 16) at lower end.
12. Pull oil cooler drain tube (lower end) out of oil
cooler module and discard O-ring.
13. Remove eight oil system module assembly bolts
(M8 x 30).
14. Remove the complete oil system module including
the oil cooler and filter header as a unit (less oil
filter) and place onto a clean workbench.
EGES-265-2
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
To Next Page
Loading...
