– 63 –
CHAPTER 2 Operations of SV8500 Server
[Start]
STEP 1 Turn ON a PC to be used for CF card initialization.
STEP 2 Insert the installer CD-ROM (printed “BASIC SOFTWARE” on the label) to the CD/DVD drive
of the PC.
STEP 3 Set the PC to reboot from the CD-ROM; give the top priority to the CD/DVD drive.
Note: Refer to the PC’s manual for the BIOS setting information.
STEP 4 Reboot the PC from the CD-ROM.
• Linux is started from the CD-ROM.
• After a while, the following will be displayed.
STEP 5 Boot prompt is displayed, and then press ENTER in order to detect the device name automati-
cally (command is not required).
Note: If automatic detection is not available, specify the correct device.
Options are: usb ide
scd0 scd1 scd2 scde3
scd4 scd5 scd6 scde7
hda hdb hdc hdd
hde hdf hdg hdh
auto
none (test only)
The default is auto.
boot:
boot:
To Next Page
Loading...
