– 484 –
CHAPTER 3 System Messages
Note: When office data for WLAN Handset/Standard SIP process is registered by ASSDN/ASSDL command al-
though WLAN Handset/Standard SIP terminal is not accommodated, “35-F: FNC=01H (Service
Start.)” is output when SP is activated and “35-I: FNC=01H (Service Stop.)” is output when SP is
stopped.
Note: ASSDN/ASSDL data is usually registered although WLAN Handset/Standard SIP terminal is not accom-
modated.
Note: It takes about five minutes (Time to detect KeepAliveTimeOut) to output “35-G: FNC=01H (Service
Stop.)”, “35-I: FNC=01H (Service Stop.)” or “35-I: FNC=02H (SIP Wireless Terminal Backup Service
Stop.)” after WLAN Handset/Standard SIP process stopped the operation.
Executed
(Active/Standby)
Reset operation from PCPro
(Active side)
• 35-F (Information), FNC=02H (Reset Indica-
tion from PCPro.), ST=02H (Active)
• 35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
• 35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Reset operation from PCPro
(Standby side)
• 35-F(Information), FNC=02H (Reset Indica-
tion from PCPro.), ST=02H (Active)
• 35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Changeover by a failure
• 35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
• 35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Changeover operation from
PCPro
• 35-F(Information), FNC=03H (ACT Change
Indication from PCPro.), ST=02H (Active)
• 35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
• 35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Mismatch in redundant setting
between
SP and office data
• 35-G(Warning), FNC=03H (SIP Wireless Ter-
minal Backup Service Configuration Failure.)
Terms for outputting System Message
SIP Wireless Terminal
Backup
Operation/Event System Message
To Next Page
Loading...
