– 483 –
CHAPTER 3 System Messages
• Terms for outputting System Message
Each operation related to WLAN Handset/Standard SIP process and system message that is output when an
event occurs is as follows.
Note: Several messages may be output for one event.
Terms for outputting System Message
SIP Wireless Terminal
Backup
Operation/Event System Message
Not executed
Operation is started.
• 35-F (Information), FNC=01H
(Service Start.), ST=01H (Single)
Operation is stopped.
• 35-I (Stop), FNC=01H
(Service Stop), ST=01H (Single)
Note: It takes about five minutes to output the mes-
sage after operation is stopped.
Reset operation from PCPro.
• 35-F (Information), FNC=02H
(Reset Indication from PCPro),
ST=01H (Single)
• 35-F (Information), FNC=01H
(Service Start.), ST=01H (Single)
Executed
(Active/Standby)
Operation is started.
• 35-F (Information), FNC=01H
(Service Start.), ST=02H (Active)
• 35-F (Information), FNC=01H
(Service Start.), ST=03H (Standby)
Operation of both SP are
stopped.
• 35-G (Warning), FNC=01H
(Service Stop.), ST=03H (Standby)
• 35-I (Stop), FNC=02H
(SIP Wireless Terminal Backup Service Stop.)
Note: It takes about five minutes to output the mes-
sage after operation is stopped.
Note: If single operation is stopped, “35-I (MJ),
FNC=02H (SIP Wireless Terminal Backup
Service Stop.)” is not output.
To Next Page
Loading...
