– 756 –
CHAPTER 7 Maintenance Commands
<Channel Status>
CNT: Count
LENS: Equipment Number
Control: Status of Control Channel
ST-B1: Status of Speech Channel (ST-B1)
ST-B2: Status of Speech Channel (ST-B2)
ST-B3: Status of Speech Channel (ST-B3)
PH LENS: Accommodation of PH
Buttons
Get: Retrieve the information.
Exit: Exit this command.
Execute: Execute the reset transaction.
<Redundancy>
SIP Server ID: ID of SP [1-127]
FPC: Fusion Point Code [1-253]
ACT Server ID: Server condition is operated in Active-mode
STBY Server ID: Server condition is operated in Stand-by mode
WAIT Server ID: Server condition is operated in changing
OFF Server ID: Server condition is operated in suspending
Buttons
Get: Retrieve the information.
Exit: Exit this command.
Reset: Execute the reset transaction for specified SP in SIP Server ID.
Note 1: Only when the SP is in Active mode or Standby mode, reset will be executed, if in other conditions, reset
will not be executed.
To Next Page
Loading...
