– 757 –
CHAPTER 7 Maintenance Commands
Note 2: On Single SP, reset can be executed.
Note 3: When reset transaction is executing, the remaining time until Time-out is displayed, if reset transaction
is not completed within 3 minutes, the task will be stopped with displaying “Time-out”.
SP mode change: Execute forcible system changeover between Active-side SP and Standby-side
SP.
Note 1: Only when system ID is specified in SIP Server ID and the system is redundant, this button is displayed.
Note 2: Only when the SP is in Active mode and another SP is in Standby mode, system changeover can be ex-
ecuted.
Note 3: When system changeover is executing, the remaining time until Time-out is displayed, if system change-
over is not completed within 3 minutes, the task will be stopped with displaying “Time-out”.
To Next Page
Loading...
