– 759 –
CHAPTER 7 Maintenance Commands
Output Data
RESULT field:
F_OK: Database file is normal. (Execute button is active.)
F_ERR: Database file error occurs. (Execute button is not active. Data assignment is not
available.)
The error occurs when database file is read out because of the following causes.
R_OK: Data assignment/deletion is finished.
R_ERR: Data assignment/deletion error occurs.
For the details of error, refer to the operation log file (“PBX Alias name”Op.log)
stored in Maintenance Console (PC).
R_NOT: No deleting data exists.
Input Data Cause of Error
INDEX • Data is not input.
TN • Data is not input.
• “0-9” is not input with single byte.
• TN is not input correctly in the range of 1-63 (ASYD command
SYS1, INDEX 8).
UGN • Data is not input.
• “0-9” is not input with single byte.
• UGN is not input correctly in the range of “1-255”.
NAME • Data is not input.
• Input character is not available for PCPro.
• A blank space is left at the end of name.
• Input name is beyond 24 characters.
CNT • Data is not input.
• 0-9 is not input with single byte.
• Input name is beyond “20”.
DC • The number of input DC is fewer than CNT.
• Digit Code (0-9, #, *) is not used.
• Input data is beyond 32 digits.
• The same DC exists in the same row.
To Next Page
Loading...
