– 760 –
CHAPTER 7 Maintenance Commands
Database File for Batch Assignment
To draw up the database for System Phone Book data, the database file should be made under conditions below.
Sample Format of Database File
Conditions:
• The database file is drawn up with text file only. The file extension should be “*.txt”.
• Data needs to be input to the file with the “tab delimited” text format.
• All data for one case should be included in a row.
• The end of a row is recognized by inputting “[CR+LF]”.
• “CPBKN_DATAFILE ‘[CR+LF]’” needs to be input in the first row of the file by all means.
• Data for DC needs to be input to left justify.
• Data for CNT takes priority over the number of input DC. For example, only five DCs can be as-
signed if “5” is input in CNT field even though seven DCs have been already input in database.
• When “0” is input in CNT field, whole data in relevant row will be deleted.
• When “;” is input in left most part of each row, the row is regarded as comment row.
• One-tab character needs to be input between data to separate each data. However, Two-tab character
input is required between INDEX and TN data input field because RESULT field is not used while
drawing up database.
• Input data will be active only when data are input in the following order.
Note 1: Two-tab character input is required between INDEX and TN data input field because RESULT
Note 2: Above data input is an example.
field is not used while drawing up the database.
CPBKN_DATAFILE [CR+LF]
;
;Database File for Batch Assignment
;INDEX RESULT TN UGN NAME CNT DC_01 DC_02 DC_03
0001
63
255
Suzuki
3
1000
2000
3000
[CR+LF]
0002
63 100
Abiko
20 20001 20002 20003
20020
DC_20[CR+LF]
...
...
[CR+LF]
Input one-tab character between data.
Note 1
;
To Next Page
Loading...
