– 802 –
CHAPTER 7 Maintenance Commands
TELN: Enter Telephone Number Note 2
Note 2: This parameter is valid when “TelephoneNumber (NDM)/(LDM)” is selected as Kind of Station.
KIND: Kind of Release Note 3
•Soft Reset
• PH Control Data Clear and Soft Reset
• PH Control Data Clear
Note 3: To display this parameter, select an item in the Detail data list, and then click the Execute button. Avail-
able terminals in this parameter varies depending on the IP KIND. (IP KIND is displayed in the Detail
data list.)
<IP KIND>
DtermIP X IP terminal
Soft Dterm X Soft Phone (Proprietary Protocol)
Smart Phone -
Analog MC X Analog 2MC
Digital MC -
IP-CS NA IP-BS
IP-VPS -
MG (Analog) -
MG (Digital) -
MG (ISDN BRI) NA MG (BRI)
MG (ISDN PRI 1.5M) NA MG (PRI) [MG-24PRIA], MG-PRI
MG (ISDN PRI 2M) NA MG (PRI) [MG-30PRIA], MG-PRA
SIP-MG NA MG (SIP)
MCMG_COT NA Trunk side of MC&MG-COT
MCMG_aMC X Terminal side of MC&MG-COT
Voice Server X VS-32 (Proprietary Protocol)
SIP Station X DtermIP (SIP)
MPH NA
SPterm X DT700 Series
Soft SPterm X Soft Phone (SIP)
SIP-VPS -
MCMG (7COT)_COT NA Trunk side of MCMG [SCA-7COTA]
MCMG (7COT)_aMC X Terminal side of MCMG [SCA-7COTA]
8MC (SIP) X 8LC Card
To Next Page
Loading...
