– 862 –
CHAPTER 7 Maintenance Commands
Get:Reads out and displays the connected IP device data.
Ping Execute:Executes ping test to verify that a particular IP address exists and can accept request, and to
see how long it takes to get response. Ping test is executed to the IP address marked in the check box on
the list.
File output:Outputs the listed data as a CSV file format.
Exit:Exits the command window.
<MGC tab>
[Output Data]
MGC Kind:1U MGC
System-ACT/System-0/System-1
IP Address
Note 4
Ping result (system-0)
Ping result (system-1)
Note 4: When the IP address of MGC is not assigned by the ADTM command or assigned to 0.0.0.0, only Lan2
indicates the default data.
<IP Terminal tab>
[Input Data]
View Type
• Equipment Kind
LENS Input Type: All / Collective
Specify the range of LENS in the START and END box when Collective is selected.
Click the type of target IP device. The check box “All Equipment” is provided to select all the types.
•Terminal
DtermIP
Soft Phone (SP20)
Note 5
Inaset
Soft Phone (SP21)
Soft Phone (SP30)
Note 5
•Media Converter
To Next Page
Loading...
