– 861 –
CHAPTER 7 Maintenance Commands
[Output Data]
System-0 operating status
Note 1
System-1 operating status Note 1
System-Act IP address Note 2
System-0 IP address Note 2 Note 3
System-1 IP address Note 2 Note 3
Subnet Mask (default: 255.255.0.0) Note 2
Note:
Information of LAN2 will be displayed.
Note 1: The color for the operating status means as shown below.
Note 2: When the IP address of MGC is not assigned by the ADTM command or assigned to 0.0.0.0, the default
data is indicated as follows.
Note 3: In single configuration, the blank is indicated.
• Buttons
COLOR STATUS ping
Green Operating normal (ACT) Available
Yellow Operating normal (STBY) Available
Red Stop Not available
Gray Not mounted Not available
SP/LP LP Number Default IP Address (System-0) Default IP Address (System-1)
SP - 172. 16. 253. 0 172. 16. 253. 1
LP 0 172. 16. 253. 30 172. 16. 253. 31
LP 4 172. 16. 253. 38 172. 16. 253. 39
LP 8 172. 16. 253. 40 172. 16. 253. 41
LP 12 172. 16. 253. 48 172. 16. 253. 49
LP 16 172. 16. 253. 50 172. 16. 253. 51
LP 20 172. 16. 253. 58 172. 16. 253. 59
LP 24 172. 16. 253. 60 172. 16. 253. 61
LP 28 172. 16. 253. 68 172. 16. 253. 69
To Next Page
Loading...
