NEC UNIVERGE SV8500 - Page 958

– 911 –
CHAPTER 7 Maintenance Commands
Type 2: By MG, Unit
Display of Scanning by Designating Unit (Figure 7-8)
Port Status on
Circuit Card Basis
ID: On-line Status
BY: Make Busy/Not Mounted
Port Status on
Circuit Level Basis
0: Not Assigned
1: Line Idle
2: Line Busy
3: Make Busy
4: Lockout
5: Status 5
Figure 7-8 Port Status Report (MG, Unit) Display
Scanning of Port Status (SPTS)
1: by MG
2: by MG, Unit
3: by MG, Unit, Group
MG
0
Interval
10
SCAN
STOP EXIT
Type
Dynamic Port Status Report (MG/UNIT)
Port Status
0: Not Assigned
2: Line Busy
4: LockOut
Status
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31Group
BY BY BY BY BY BY ID BY BY BY ID BY ID BY ID BY BY BY BY BY BY BY BY BY BY BY BY BY BY BY BYBY
-- -- -- -- -- -- -- -- -- -- TK -- DT -- DT -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
7
00000030 0 03010300000000000000000
-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
Unit
1
1: Line Idle
3: Make Busy
5: Status5
Type
Level
DL
6 00000030 0 03010300000000000000000
5 00000030 0 03010300000000000000000
4 00000030 0 03010300000000000000000
3 00000010 0 03010300000000000000000
2 00000010 0 03010300000000000000000
1 00000010 0 03010300000000000000000
0 00000030 0 03010300000000000000000