NEC UNIVERGE SV8500 - Page 960

– 913 –
CHAPTER 7 Maintenance Commands
When Group-Trunk is Designated (Figure 7-10)
RT: See Table 7-2.
TK: Trunk Number
TCL: Trunk Class
Figure 7-10 Port Status Report (MG, Unit, Group) Display—Designating Group-Trunk
Table 7-2 Route Number Explanation
DATA MEANING DATA MEANING
901 Attendant Console 902 Originating Register Trunk
903 Incoming Register Trunk 904 MF Receiver
905 Sender Trunk DP/PB 906 PB Receiver for Automated Attendant Service
907 AMP 908 Not used
909 Three-Way Conference Trunk 910, 911 Not used
913 Three-Way Conference Trunk for ATTCON 914 Not used
915 Night Attendant 916 MFC Register
917 MFC Sender 918 Not used
919-926 Modem 927, 928 Not used
929 MFC Sender 930 Rate Adapter Conversion Trunk
931 Not used 932-947 Not used
Scanning of Port Status (SPTS)
1: by MG
2: by MG, Unit
3: by MG, Unit, Group
MG
0
Interval
10
SCAN
STOP EXIT
Type
Dynamic Port Status Report (MG/UNIT/GROUP)
PKG Type: TK
PKG Status: ID
SP No: 3010
Issue: 5
7
Unit
0
Level
6
5
Group
13
STATUS
--
--
--
4 --
3 Idle
2 Idle
1 Idle
0 Idle
TN STN TEC RT
10
10
10
10
TK
4
3
2
1
TCL
TIE Line
TIE Line
TIE Line
TIE Line