_____________________________________________________________________________
LB9 User’s Guide 1011/1523
User Name - Specify the user account of the FTP site.
User Password - Specify the user password of the FTP site.
Server Address - Enter the IP address of the TFTP server. The factory default is 0.0.0.0.
Link-Local Address - Indicate whether to use IPv6 link local address to transfer.
Transfer File Path - Enter the path on the TFTP server where the selected file is located. You may
enter up to 160 characters. The factory default is blank.
Transfer File Name - Enter the name on the TFTP server of the file you want to download. You may
enter up to 32 characters. The factory default is blank.
File Name In Switch - Enter the name on the switch of the file you want to save. You may enter up
to 30 characters. The factory default is blank.
Start File Transfer - To initiate the download you need to check this box and then select the submit
button.
Non-Configurable Data
The last row of the table is used to display information about the progress of the file transfer. The
screen will refresh automatically until the file transfer completes.
Command Buttons
Submit - Send the updated screen to the switch and perform the file download.
To Next Page
Loading...
Need help?
General