_____________________________________________________________________________
LB9 User’s Guide 856/1523
8.8.2 Configuration Commands
8.8.2.1 ipv6 mld-proxy
This command enables MLD-Proxy on the router. To enable MLD-Proxy on the router, you must enable
multicast forwarding. Also, make sure that there are no other multicast routing protocols enabled n the
router.
no - This command disables the MLD-Proxy on the router.
Default Setting
Disabled
Command Mode
Interface Config
8.8.2.2 ipv6 mld-proxy reset-status
This command resets reset the host interface status parameters of the MLD-Proxy router. This
command is only valid when you enable MLD-Proxy on the interface.