Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 908/1523
9.4.2 Configuration Commands
9.4.2.1 ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
<no> - This command disables OSPF on a router interface or loopback interface.
Default Setting
Disabled
Command Mode
Interface Config
9.4.2.2 ipv6 ospf areaid
This comm
and sets the OSPF area to which
the specified router
interfac
e belongs. The <areaid
> is an
IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of
<0-4294967295>. The <areaid> uniquely identifies the area to which the interface connects. Assigning
an area id, which does not exist on an interface, causes the area to be created with default values.
ipv6 ospf areaid <areaid>
<areaid> - is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in
the range of <0-4294967295>.
Default Setting
None
Command Mode
Interface Config
To Next Page
Loading...
Need help?
General