_____________________________________________________________________________
LB9 User’s Guide 852/1523
8.8 MLD Proxy Commands
MLD-Proxy is the IPv6 equivalent of IGMP-Proxy. MLD-Proxy commands allow you to configure the
network device as well as to view device settings and statistics using either serial interface or telnet
session. The operation of MLD-Proxy commands is the same as for IGMP-Proxy: MLD is for IPv6 and
IGMP is for IPv4.MGMD is a term used to refer to both IGMP and MLD.
8.8.1 Show Commands
8.8.1.1 show ipv6 mld-proxy
This command displays a summary of the host interface status parameters.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Interface index: The interface number of the MLD-Proxy.
Admin Mode: States whether the MLD-Proxy is enabled or not. This is a configured value.
Operational Mode: States whether the MLD-Proxy is operationally enabled or not. This is a status
parameter.
Version: The present MLD host version that is operational on the proxy interface.
Number of Multicast Groups: States the number of multicast groups that are associated with the
MLD-Proxy interface.
Unsolicited Report Interval: The time interval at which the MLD-Proxy interface sends unsolicited
group membership report.
Querier IP Address on Proxy Interface: The IP address of the Querier, if any, in the network
attached to the upstream interface (MLD-Proxy interface).
Older Version 1 Querier Timeout: The interval used to timeout the older version 1 queriers.
Proxy Start Frequency: The number of times the MLD-Proxy has been stopped and started.
To Next Page
Loading...
Need help?
General