Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 281/1523
6.4.2 Configuration Commands
6.4.2.1 spanning-tree
This command sets the spanning-tree operational mode to be enabled.
spanning-tree
no spanning-tree
no - This command sets the spanning-tree operational mode to be disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
Default Setting
Disabled
Command Mode
Global Config
6.4.2.2 spanning-tree protocol-migration
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
spanning-tree protoc
ol-migration {<s
lot/port> |
port-channel <portcha
nnel-i
d> | all}
no spanning-tree prot
ocol-m
igration {<slot/port
> | port-c
hannel <portchannel-
id> | all}
<slot/port> - is the desired interface number.
<portchannel-id> - is the desired interface number. The range of port-channel ID is 1 to 4.
all - All interfaces.
no - This command disables BPDU migration check on a given interface. The all option disables
BPDU migration check on all interfaces.
Default Setting
None
Command Mode
Global Config
To Next Page
Loading...
Need help?
General