Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 199/1523
6.3.3 Telnet Session Commands
6.3.3.1 telnet
This command establishes a new outbound telnet connection to a remote host.
telnet <ip-address|hostname> [port] [debug] [line]
<ip-address|hostname> - A hostname or a valid IP address.
port - A valid decimal integer in the range of 0 to 65535, where the default value is 23.
debug - Display current enabled telnet options.
line - Set the outbound telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’.
Default Setting
None
Command Mode
Privileged Exec
User Exec
6.3.3.2 show line vty
This command displays telnet settings.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Remote Connection Login Timeout (minutes): This object indicates the number of minutes a
remote connection session is allowed to remain inactive before being logged off. A zero means there
will be no timeout. May be specified as a number from 0 to 160. The factory default is 5.
Maximum Number of Remote Connection Sessions: This object indicates the number of
simultaneous remote connection sessions allowed. The factory default is 5.
To Next Page
Loading...
Need help?
General